When cooling alone cannot hold the moisture level your process or product requires, you need dedicated humidity control. Winsteam provides humidity control as a standalone service — integrated with your existing ACMV system and delivered under a single contract.
From establishing the moisture load to installing, integrating and maintaining the equipment — with Winsteam managing the ACMV interface throughout.
We survey the space to establish where moisture is coming from — infiltration, occupancy, the process itself, fresh air intake — and what humidity or dew point the application actually requires. Many enquiries begin without a defined target; establishing it correctly is what keeps the equipment properly sized.
Specification and supply of desiccant or refrigerant dehumidification equipment appropriate to the target humidity. Low dew points generally call for desiccant systems; moderate humidity reduction can often be achieved with refrigerant-based equipment at lower running cost.
This is Winsteam's core competence. Humidity equipment rarely stands alone — it has to be tied into existing ductwork, air handling units, fresh air provision and controls without upsetting the cooling the space already relies on. We handle that interface, the installation and the commissioning.
Humidity sensors, setpoint control, alarm thresholds and integration into your building management system, so the condition is monitored continuously rather than discovered when a product batch fails or condensation appears.
Where condensation is already occurring — on ceilings, ductwork, cold surfaces or in kitchens and chilled rooms — we diagnose whether the cause is humidity, insulation, air balance or fresh air provision before recommending equipment. Not every condensation problem needs a dehumidifier.
Scheduled servicing of humidity control equipment alongside your ACMV preventive maintenance contract, including sensor calibration, so the humidity you read on the panel is the humidity in the room.
Singapore's ambient humidity runs high year-round, so any space with a tight moisture specification needs active control rather than cooling alone.
Production and packaging areas where humidity is part of the product specification, and cleanroom-adjacent spaces requiring stable conditions.
Assembly and test areas where moisture affects yield, static behaviour or component storage. See also factory and industrial ACMV.
Chilled preparation and storage spaces where warm humid air meets cold surfaces, producing condensation, frost and slip hazards.
Processes where powders cake, coatings fail to set, or shelf life is affected by ambient moisture.
Document, artwork and equipment storage where sustained high humidity causes mould, corrosion and material degradation.
Facilities where humidity must stay inside ASHRAE thermal envelope limits alongside temperature. See data centre cooling.
Winsteam takes the humidity requirement end to end — survey, equipment, installation, integration, commissioning and maintenance. You are not left coordinating an equipment supplier against an installer against whoever maintains it afterwards. One contractor is accountable for the condition being met.
Most humidity problems are not solved by equipment alone. They are solved by getting the air balance, fresh air provision, ductwork and controls right around the equipment — which is ordinary ACMV work, and where most of the risk sits on these projects.
Retrofits are phased around production and operating hours, with method statements and risk assessments before mobilisation — the same approach we use for hotels and commercial buildings.
We will tell you when a dehumidifier is not the answer. Condensation and clamminess are often caused by air balance, insulation or fresh air faults that cost far less to correct than a humidity plant.
Common questions from facilities managers, production heads and building owners about humidity control in Singapore.
Tell us the space, the problem and the target condition. We'll arrange a site survey at no obligation and tell you straight whether equipment is the right answer.
+65 9380 8176 · winsteam@winsteam.sg
Related services:
ACMV Installation & Maintenance · Ventilation Contractor · Factory ACMV